Some recommendations on getting your kart ready for Enduros.
- Check your seat mount holes
- Make sure your rear crash is zip tied to the chassis and the bolts are taped over
- Shout your yourself a new throttle cable. Use it for a couple of practice sessions and check the adjustment before race start
- Put new side pod mount bolts in
- Wrap a spring or wire around your exhaust springs
- Check your header pipe welds – have a spare header flex and springs
- Make sure you have a brake safety cable (throttle pedal to Master cylinder)
- Bleed your brakes with brand-new brake fluid
- Make sure your floor tray bolts are in good condition
- Two new chains – use both a couple of times before the Enduro to get the initial stretch out of them
- Secure your fuel tank – zip tie the retaining nut as the minimum
- Make sure your numbers a clearly visible. There are no rule on the number colours – they just need to be easy to see from tower
- Double check your wheel nuts, and hub nuts (if the nyloc is worn, replace them)
- If you have beed locks spray them with soapy water to make sure they do not leak
- Put new batteries in your Micron/Alfano, and
- Zip tie the air box to the seat.